:(Īt one point I did mean to get round to it, but I've always had other things that need to be done first, unfortunately.Īt the moment, I don't plan to or have time to write some proper documentation, but in itself, the GUI should (hopefully!) be fairly simple to use: at various points, it offers advice if needed to try and help you get started, and help you avoid problems. Sudo mount -o ro,loop,offset=YOUR_OFFSET -t ntfs /path/to/1tb.Sorry, at the moment there are no tutorials or help pages. Your commands will be more like mkdir /mnt/image That's why there is offset=$(2048*512)) as file/fdisk/cfdisk shows it in sectors (although you can change units in fdisk/cfdisk). So proper mount line would be: # mount -tvfat -oloop,offset=$((2048*512)) sda.img /mnt/sda1Īs you have to inform mount where the actual partition starts - with offset option which is byte offset. Should give you something more like: (that's my memory stick you get the idea)Īll they should show you geometry of your disk (in image) so you can find out where is beginning of partition to mount. ![]() Use file to gen information on your image. Second, your image is going to be an image of whole drive which means you have to know where partitions starts. I checked the official Launchpad GUI site but I didn't find any tutorials or guides or anything useful. Is there a correct way of going about this? No idea why my drive got unmounted, converted to a "loop device" (whatever that is) and why I can't just get my data and then mount my device again. I'm new to this whole scene so I'm really confused at the moment. The file is currently sitting on a separate hdd and the 1tb hdd I'm trying to recover is inaccessible: dev/sda, not /dev/sda1)? Or the other way around? Maybe the wrong device is used? Or the whole disk instead of a The device '/dev/loop2' doesn't seem to have a valid NTFS. Sudo mount -t ntfs "/media/user/e3cfeead-6e65-4af5-beb8-bbfa12fbdaa5/1tb.img" /dev/loop0įailed to mount '/dev/loop2': Invalid argument So I tried various terminal commands to no avail, getting errors such as: So I went into Disks to see if I could mount it, but could not because it was now two loop devices: Went into Computer and found that the source drive was now unmounted.Select source (formatted hdd), no log, destination (img file inside separate hdd) and set to fastest recovery then click start. ![]() I installed ddrescue-gui and performed the following tasks: I'm trying to recover data after formatting my hdd.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |